SOHC.co.uk Forums > Project Board
OAP Ted's CB400F2 rebuild - engine not run for about 12 years.
Laverdaroo:
--- Quote from: Macabethiele (Ted) on October 01, 2021, 03:54:25 PM ---
--- Quote from: Oddjob on October 01, 2021, 02:19:12 PM ---You can buy the pivot pins in stainless as well Ted, might as well complete the look. Plus it stops them rusting.
--- End quote ---
I can't PM you as you are blocked for messages from members.
Do you have a source for the correct SS front foot rest pivot pins please?
A link would be good.
Thanks in advance Ted
Hey Ted,
I used these and they were spot on even though they were cheap, see what you think mate....
https://www.ebay.co.uk/itm/294294447937?hash=item448550e741:g:6FQAAOSw-LJbdCNv
--- End quote ---
Sesman:
I bought some for the 550. The front pivots were fine, but the rears were incorrect diameter, being to large.
McCabe-Thiele (Ted):
My SS footrest pins arrived today - front & rear the correct size as per Laverdaroo link.
McCabe-Thiele (Ted):
Another good reason to never ride in the rain - good shout Oddjob - they look well tidy!
As it lashes down in rain here in Derby I am reminded of my many trips from Derby to Chester in 1967/8 on my Honda 250 Dream in all weathers as a teenager- I could not afford leathers as a student (I dreamt of a Belstaff jacket) so I wore fully water proof rubber leggings, hiking boots, an Anorak and for the winter some big leather Gauntlets - I did have a decent helmet.
Laverdaroo:
Glad they're what you wanted Ted, (thumbs up emoji)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version