SOHC.co.uk Forums > CB350/400

Fitting DSS coils

<< < (2/2)

Athame57:

--- Quote from: Macabethiele on September 04, 2020, 08:53:49 PM ---
Presumably you have tried swapping the mounting posts from left side  to right side  at one end or even both ends to make up the length difference? You could then lop off the bit in the way if you get my drift. Alternatively you can rotate the posts and insert a simple 90 Deg bracket like on a kitchen unit type fitting.

--- End quote ---
I'll investigate tomorrow to see if a bit of hacksaw butchery will help! ;)

McCabe-Thiele (Ted):

--- Quote from: Athame57 on September 04, 2020, 09:26:30 PM ---
--- Quote from: Macabethiele on September 04, 2020, 08:53:49 PM ---
Presumably you have tried swapping the mounting posts from left side  to right side  at one end or even both ends to make up the length difference? You could then lop off the bit in the way if you get my drift. Alternatively you can rotate the posts and insert a simple 90 Deg bracket like on a kitchen unit type fitting.

--- End quote ---
I'll investigate tomorrow to see if a bit of hacksaw butchery will help! ;)

--- End quote ---

I used a junior hacksaw and some cutting wheels in my drill - be careful it feels like a cast alluminium bracket so it will break.

Navigation

[0] Message Index

[*] Previous page