SOHC.co.uk Forums > CB350/400

Evaporust Trial on fuel tap front plate.

<< < (7/8) > >>

AshimotoK0:
These are what I used yonks ago but must admit I just prep everything and take it to Allenchrome these days. I actualy used a lab bench supply in constant current mode but this was for Trigger I believe and used the LM338 regulator I suggested Ian use.

[ Guests cannot view attachments ]

Oggie400F:
Ash
I’ll message you about the controller.
Ian

AshimotoK0:

--- Quote from: Oggie400F on September 14, 2020, 10:22:58 PM ---
SteveD
"There aren’t many on here will have any idea what you are on about"


Ash
I’ll message you about the controller.
Ian

--- End quote ---

Steve ... never under estimate the thirst for knowledge of your readership  ;D ;D ;D  Particularly if they come from East Yorkshire   ;D ;D

taysidedragon:
I took one look at Ash's setup and immediately thought, send my stuff to the platers!
 :D :D

AshimotoK0:

--- Quote from: taysidedragon on September 15, 2020, 09:43:18 AM ---I took one look at Ash's setup and immediately thought, send my stuff to the platers!
 :D :D

--- End quote ---

I don't tend to use it much now  just for small items ...I send 99.5% to Allenchrome now.

However, a lot of people like to have a go themselves ...like Oggie400F ...I loaned my kit & chemicals to another bloke in Hull a few years back and he zinc plated everything on his CB750K2 with it and the bike was featured in Classic Bike magazine bikes of the year.

Navigation

[0] Message Index

[#] Next page

[*] Previous page