SOHC.co.uk Forums > CB350/400

Oops or **** it! Rear wheel re-spoke update

<< < (5/5)

waffey:
sorry to jump in as well. I'm looking to rebuild my rear wheel soon.

I used the front wheel rim and spokes from WEMOTO. Quality seems to be good but they dont have the rear.
r
Is it only DSS that have stock ear rims or can I source them else where?

billdn:
Well that was easier with the DID rim than the other ones, I've managed to get around 1mm run out on the lateral (side to side ) which I feel is acceptable but I'm not sure on the radial -currently about 1mm measured with a feeler gauge between pointer and rim edge- looks okay to me but should it be lower.?

taysidedragon:

--- Quote from: billdn on October 16, 2020, 10:08:30 AM ---Well that was easier with the DID rim than the other ones, I've managed to get around 1mm run out on the lateral (side to side ) which I feel is acceptable but I'm not sure on the radial -currently about 1mm measured with a feeler gauge between pointer and rim edge- looks okay to me but should it be lower.?

--- End quote ---

I think that's within tolerance, but try and get it closer if you can.

Bryanj:
Honda's (and mot) tolerance is 3mm for each

billdn:
BryanJ - thanks for that, well under 3mm which does seem an awful lot but finished at 1.5mm for both so good enough for Jazz :)

Navigation

[0] Message Index

[*] Previous page