SOHC.co.uk Forums > CB350/400

Swing Arm Insertion

<< < (2/2)

Bryanj:
The swing arm will always pivot as long as the collar is the correct length as that should be pinched between the frame sides by the bolt

Mag1:
How thick is the powder coating?, when I was doing mine it should be a sung fit but not too hard to install. Remember that when torqued up it will pull together tight. If I remember when I did my bike I filed all the coating off and greased the cups and frame.

Mag1:

--- Quote from: Mag1 on October 03, 2020, 06:47:31 PM ---How thick is the powder coating?, when I was doing mine it should be a sung fit but not too hard to install. Remember that when torqued up it will pull together tight. If I remember when I did my bike I filed all the coating off and greased the cups and frame.

--- End quote ---

Sorry should have said I have 750, but should be same method

waffey:
thank you all you're reply's, i'll attempt tomorrow by checking the amount of powder coating on the frame etc

ta

Navigation

[0] Message Index

[*] Previous page