SOHC.co.uk Forums > CB350/400

Castellated Clutch Nut - how tight ?

(1/2) > >>

McCabe-Thiele (Ted):
I've been looking for a torque setting for the above nut - does 30Lb-ft sound about right?

Deano400:
Can't say it's 100% but one of the manuals I have has these torque settings:
[ Guests cannot view attachments ]
So 30 looks ok.

McCabe-Thiele (Ted):

--- Quote from: Deano400 on October 09, 2020, 10:30:18 PM ---Can't say it's 100% but one of the manuals I have has these torque settings:
(Attachment Link)
So 30 looks ok.

--- End quote ---

Thanks Deano one of my manuals does not seem to say or calls it something else the other had a figure like your chart but it seemed a tad on the low side - I guess I'm used to torque figures on cars that tend to be somewhat higher. Also its out of range on my old Britool torque wrench.

Trigger:
Start at 30 and if the locking tabs are not lined up to bend over in place than, you tighten until a tab has a home to sit in  ;)

bobv7:
This is the official work shop tool from the 1970's which may give a clue to how much torque is needed.
[ Guests cannot view attachments ]

Navigation

[0] Message Index

[#] Next page