SOHC.co.uk Forums > CB350/400
Clutch operating camshaft thingy - worn or normal?
Nurse Julie:
--- Quote from: Macabethiele on October 10, 2020, 01:47:24 PM ---
--- Quote from: Trigger on October 10, 2020, 11:38:02 AM ---They have not been available for years. PM Julie as i will have some somewhere.
--- End quote ---
I've measured them up they are 10 mm bearings - my brother should have some that size - if not I will contact NJ. Thanks
Not sure about the O ring its a small critter do you know the size by any chance?
--- End quote ---
The ball bearings are 10.25mm, so 10mm ones will fall out of the little baskets. I think the 10.25 size is specifically licenced to Honda, as I have searched worldwide for replacements and can't find any. Even in imperial, there is no exact equivalent.
McCabe-Thiele (Ted):
--- Quote from: Nurse Julie on October 10, 2020, 02:01:09 PM ---
--- Quote from: Macabethiele on October 10, 2020, 01:47:24 PM ---
--- Quote from: Trigger on October 10, 2020, 11:38:02 AM ---They have not been available for years. PM Julie as i will have some somewhere.
--- End quote ---
I've measured them up they are 10 mm bearings - my brother should have some that size - if not I will contact NJ. Thanks
Not sure about the O ring its a small critter do you know the size by any chance?
--- End quote ---
The ball bearings are 10.25mm, so 10mm ones will fall out of the little baskets. I think the 10.25 size is specifically licenced to Honda, as I have searched worldwide for replacements and can't find any. Even in imperial, there is no exact equivalent.
--- End quote ---
When I measured mine they were 10.12 mm and are more like a golf ball texture. I need 3 that are much better not sure what to do.
Deano400:
Steve has got some.
https://www.400fourbits.co.uk/#engine
cliff7:
13/32" balls are available (0.07mm too big). Does anybody know if these would do. https://simplybearings.co.uk/shop/product_info.php?products_id=38926&vat_inc=true
McCabe-Thiele (Ted):
I've sourced one from NJ thanks guys. I think 13/32 is too big for the cage and the bit they sit in. The size is closest to 0.4 inch.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version