SOHC.co.uk Forums > CB500/550
Forks - Repo or Rechrome?
Nurse Julie:
--- Quote from: philward on October 10, 2020, 10:50:25 PM ---Thanks Julie - its just the chrome that is bad - do I need to de-rust and polish before sending?
--- End quote ---
No Phil. You don't need to do any prep whatsoever.
Nurse Julie:
--- Quote from: Nurse Julie on October 10, 2020, 10:53:43 PM ---
--- Quote from: philward on October 10, 2020, 10:50:25 PM ---Thanks Julie - its just the chrome that is bad - do I need to de-rust and polish before sending?
--- End quote ---
No Phil. You don't need to do any prep whatsoever.
--- End quote ---
Also Phil, if you send them the rear wheel spindle as well, they will hard chrome the big round flat bit on the end for just a few quid extra. Just put a note in saying you just want the end done and not the whole spindle.
philward:
Great - thanks Julie
SumpMagnet:
Had mine done with Philpotts. Can't fault the work or the service.
Collect from the door, do the work, and deliver back...and the chrome finish is very durable. Had a set of SV forks done a while back, and the chrome was far better than the stock finish.
royhall:
Had a few done at Dynasurf now. They are just as good as Philpotts only cheaper. Plus I always send the top nuts and they did them no charge.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version