SOHC.co.uk Forums > CB350/400

Fancy a reverse cone mega!

(1/3) > >>

billdn:
At the risk of upsetting some people I want to fit a a mega exhaust , having purchased one from Modern motorcycle company - it arrived and build wise looks good BUT it doesn't seem to fit over the muffler gasket. The outside diameter of the muffler gasket from CSMNL is 49mm , I've read other threads where tit may be necessary to adjust the final fit!
Am i correct that the muffler from the collector box goes over the collector box outlet but inside the silencer - in which case I'd need a 49mm silencer opening which doesn't seem available.
If I adjust the gasket it will be so thin as to be of no use and would probable break, the internal diameter of the silencer is 46mm, is there an alternative to the gasket ? >:(

Bryanj:
Not officially, but you could try exhaust bandage

bobv7:
 You haven't said what the diameter of the collector box exit pipe is. If your new silencer will fit tightly over it then use exhaust sealing paste and a clamp.

Athame57:

--- Quote from: billdn on October 18, 2020, 04:50:28 PM ---, I've read other threads where tit may be necessary to adjust the final fit!

--- End quote ---
What on earth can boobs and baffles have in common?  :o

billdn:
Bryanj - thanks for that, I'll look into that.

bobv7 - that's just it the silencer is too small to go over the collector box outlet  - the outlet diameter is 47mm, so the silencer is fitting inside of instead on top - but the largest I've seen all seem to be 45mm!

Athame57 - oops, for got to proof read fist post , first post  ;)

Navigation

[0] Message Index

[#] Next page