SOHC.co.uk Forums > CB500/550

PILOT LIGHTS NOT WORKING

(1/3) > >>

Gromitdog:
Sub Wiring loom 3210-593-00 posted 27/10/20

To carry on from last post the wiring loom is now slaved in and I have managed to get most of it to work  ;D, Except for the "Pilot cluster lights" ( The light cluster give Oil Px, High Beam, Neutral, & indicators ) I can not get any of these lights to work.. >:(

I know from the wiring digram that Neutral & Oil px lights go to earth to make the circuit and neutral has to be correctly positioned in "neutral gear" / adjusted on the clutch cable to bring the light on. I have check the clutch loom for continuity and that's ok.
I also can not get the direction indicators on the pilot cluster to work individually for Left & Right to come on with the L/H & R/H indicators they work as hazard lights at the moment .

Any help or guidance would be gratefully received please I know Its hard to do via a forum

Nigel

Bryanj:
Have you put led bulbs in the indicators by chance? As to the oil and neutral are they getting power on the black wire?

Gromitdog:
Hi Bryan
Thank you for your quick reply I will go and plug in the Black wire which is Switch wire into the Pilot light loom & check if I get a power to it & hopefully it will light up..... ::)  As for the indicators I have kept all as standard bulbs nothing fancy.

Thanks for up date

Bryanj:
Would suggest that the indicator repeators are plugged in wrong, if there are two, one for each side, there should be 2 wires off each, an orrange and pale blue (one to each) and the second wire, which ought to be green (but may be black) goes to earth

Gromitdog:
Hi Bryan

Thank you for your quick reply I will check that out I already have the orange wire as L/H and pale blue as R/H both indicators front and rear work perfectly just got to sort the power out up onto the pilot cluster I am sure once I can get 1-2 lights working the rest will follow

Navigation

[0] Message Index

[#] Next page