« previous next »
Pages: [1]   Go Down

Author Topic: Hondabond for oil pump/crankcase joint?  (Read 1204 times)

Offline SeanFD

  • SOHC Expert
  • Posts: 304
  • "Still running against the wind"
    • View Profile
    • Belfast-2-Belfast-By-Bike
Hondabond for oil pump/crankcase joint?
« on: November 03, 2020, 12:09:07 PM »
When reinstalling the oil pump, is it necessary or advisable to use Hondabons or other sealant on the mating surfaces?

I haven’t seen anything to the contrary so I’m assuming that the torque on the bolts is the standard ones for M6 and M8 bolts.
Logged
CB750 K2 - See: Belfast2BelfastByBike.com
CB750 K1 - The less, said the better!
CB450 K1 - A work in progress. (Still!)
CB400F Supersport - Rusty - not any more!

Offline Trigger

  • Grogu
  • *
  • Posts: 8379
  • Engines built on reputation, not advertising.
    • View Profile
Re: Hondabond for oil pump/crankcase joint?
« Reply #1 on: November 03, 2020, 12:19:16 PM »
If it has a new o'ring that will seal  ;)
Logged

Offline SeanFD

  • SOHC Expert
  • Posts: 304
  • "Still running against the wind"
    • View Profile
    • Belfast-2-Belfast-By-Bike
Re: Hondabond for oil pump/crankcase joint?
« Reply #2 on: November 03, 2020, 12:32:57 PM »
Thanks Trigger.

It does indeed have a new o-ring, so I’ll just tighten it up.
Logged
CB750 K2 - See: Belfast2BelfastByBike.com
CB750 K1 - The less, said the better!
CB450 K1 - A work in progress. (Still!)
CB400F Supersport - Rusty - not any more!
Pages: [1]   Go Up
« previous next »