SOHC.co.uk Forums > CB350/400
Kill Switch 400/4
McCabe-Thiele (Ted):
--- Quote from: Lobo on November 14, 2020, 09:15:39 PM ---... just beware that the old Honda bullet connectors are smaller than what is commonly sold as ‘replacement bullets’. Off the top of my head I don’t know the specs.... perhaps someone can chip in with advice / best supplier here?
--- End quote ---
I think these were the ones I used 3.9 mm they do the female side as well. My old wiring loom is a bit of a mess it had the later 4.0 mm connectors in some places that had been made to fit by crushing the female side on the loom to make a contact!
https://www.ebay.co.uk/itm/Non-Insulated-Brass-3-9mm-Bullet-Connector-Terminals-Covers-Japanese-Type/332248892672?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
Lobo:
Mac... apologies but I’m not so sure - I reckon my old Hondas use 3.5mm connectors. Smooth, obviously you’re going to have to do your homework, I’m not saying Mac is wrong, nor that I’m right! Aargh.
McCabe-Thiele (Ted):
I stand corrected Lobo I am wrong you are right - I've just re-checked my old loom (again) in a few different places- it has a mixture of 3.9 mm and 3.5 mm male & female connectors!
Looking at the corrosion and insulating sleeves I think many of the originals have been replaced with 3.9 mm - a long time ago as they are green inside!
I'll be ordering some 3.5's now for when I connect the peripherals to the new loom.
McCabe-Thiele (Ted):
On my first few searches e bay does not seem to list any 3.5mm connectors.
Bryanj:
If you are fitting a new loom it may not have that size fitted
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version