SOHC.co.uk Forums > CB350/400

Rubik's Cube question - 400/4 battery & air box ??

(1/2) > >>

McCabe-Thiele (Ted):
I have finally begun to strip down the bike ready for removing the engine.

I'm struggling to remove the steel box frame that makes up the battery box & air filter box. Can this be removed from the frame without taking out the rear wheel?

There is a hardened rubber section around the oval air filter box that has been all painted over with Hamerited is this part of the air box or does it come off?

So far I've not managed to get it out - is there a secret way?

Nurse Julie:
The oval rubber should come out Ted but it's fiddly, even without being hammerited in. Have you removed the large metal oval snorkel thingy joining the air filter box to the plenum?

McCabe-Thiele (Ted):
No the oval section is firmly stuck in place by the rubber. I will have to carefully break the adhesion between the rubber and the oval part. Might have to involve the Wendy's old hair dryer to soften the rubber.

allankelly1:
Have you undone the oval julibee clip (if there is one) that clamps the oval metal pipe in place?


Sent from my iPhone using Tapatalk

McCabe-Thiele (Ted):
Yes that's off as is the 4 into 1 air box bit. I just can't wiggle what's left out of the frame it's just a bit to big to pull out until I seperate the oval pipe & sealing rubber. Tomorrow when I'm fresh in the morning. I don't want to damage either the oval pipe that's quite thin or rip the rubber by rushing the extraction tonight. I will adjust the bike lift so I can sit down to the task.

Navigation

[0] Message Index

[#] Next page