SOHC.co.uk Forums > CB350/400

Final engine bolt(s) removal question ?

<< < (2/2)

SeanFD:
I used a length of M10 (or was it M12) threaded rod through the mounting lugs front and rear. With a strong assistant it was quite ease to get the engine out and in.

I had to jiggle it a bit taking it out, so left off the rocker cover and breather when reinstalling it and wrapped some bubble-wrap around the frame, just in case. And of course left sump off too.

steven400/4:
no need for wood block engine is wider than the frame so it will rest on the frame

McCabe-Thiele (Ted):

--- Quote from: SeanFD on November 16, 2020, 10:15:50 AM ---I used a length of M10 (or was it M12) threaded rod through the mounting lugs front and rear. With a strong assistant it was quite ease to get the engine out and in.

I had to jiggle it a bit taking it out, so left off the rocker cover and breather when reinstalling it and wrapped some bubble-wrap around the frame, just in case. And of course left sump off too.

--- End quote ---

I like that method - sort of lifting it out with stretcher handles.

Navigation

[0] Message Index

[*] Previous page