SOHC.co.uk Forums > CB350/400
engine
K2-K6:
Certainly if you can get a competent enlarged thread cut with a spigot to adapt, then it would give you a good engineering solution to it.
The threads are only that bore size to flow oil through the bolt centre and not required to take much load in a conventional sense. Obviously to sucure the oil filter is a prerequisite but it would ordinarily be easier than the weld and remachine route.
steven400/4:
yes i agree mate i,ll wait to see what terry comes back with :) :) :)
robvangulik:
--- Quote from: steven400/4 on November 15, 2020, 08:40:52 AM ---thanks k2 k6 i ordered a tap yesturday before i saw your reply lol i have sent that terry a message asking what he thinks what i can do
--- End quote ---
Terry from Oz?
At least you won't have to explain anything, he'll understand what you're on about! :)
steven400/4:
i,ve sent terry a message but no reply as yet
robvangulik:
He's probably making the neighborhood unsafe, it's spring over there ;)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version