SOHC.co.uk Forums > CB350/400
Removing the rocker shafts 400/4
McCabe-Thiele (Ted):
My manual states a suitable 10 mm should be used to withdraw the rocker shafts.
Firstly are all 10mm bolts the same thread or is there a fine & coarse option? I have as yet to buy a selection of useful metric bolts so any suggestion as to suitable length is welcome.
Bryanj:
There are 3 different pitches on 10 mmbut that sounds a bit bit are you sure its not 6mm (10mm spanner)
McCabe-Thiele (Ted):
I'm going off the Haynes Manual kit shows the 550 as 6mm.
McCabe-Thiele (Ted):
--- Quote from: steven400/4 on November 18, 2020, 07:48:26 PM ---if its a 400/4 any m10 bolt out the engine will fit i use them every time
[/quote
OK but as I don't understand metric is that a fine thread?
--- End quote ---
McCabe-Thiele (Ted):
I've removed the first on by putting a close sized bolt in the hole and pushing it to one side so the threads touch - it pulled out with no effort!
Navigation
[0] Message Index
[#] Next page
Go to full version