SOHC.co.uk Forums > CB500/550
What is the word?
AshimotoK0:
--- Quote from: paul G on January 07, 2021, 12:24:53 PM ---I used the silicone tubing as well as it needs to be the .5mm wall thickness.
Cant remember where it was from but Ash gave me the link. :)
--- End quote ---
Same as I gave to Trigger see above post
deltarider:
I'll keep that in mind. Actually I hope to find something a bit thinner than 1mm and I prefer heat resistant silicone over nylon. A width of 9,5mm in total is a bit much imo.
Trigger:
--- Quote from: AshimotoK0 on January 07, 2021, 12:48:54 PM ---
--- Quote from: paul G on January 07, 2021, 12:24:53 PM ---I used the silicone tubing as well as it needs to be the .5mm wall thickness.
Cant remember where it was from but Ash gave me the link. :)
--- End quote ---
Same as I gave to Trigger see above post
--- End quote ---
I thought the link you sent me Ash was, Hill Top >>> https://www.hilltop-products.co.uk/silicone-rubber-tubing-black.html
But, i think you commented on that it was not Black, Black ;)
deltarider:
--- Quote from: Trigger on January 08, 2021, 12:21:30 PM ---Hill Top >>> https://www.hilltop-products.co.uk/silicone-rubber-tubing-black.html
--- End quote ---
According to the specs, that's what I need, but... is black really black?
As said I'd like to reuse the old OEM coils. I'd like to find some of that what seems braided around the blue and B/W wire. I need it also for around a POS wire that runs to my transistor ignition module. BTW, does any of you guys remember where those two clips are supposed to sit? Curious, the 2+3 coil doesn't have them.
AshimotoK0:
--- Quote from: Trigger on January 08, 2021, 12:21:30 PM ---
--- Quote from: AshimotoK0 on January 07, 2021, 12:48:54 PM ---
--- Quote from: paul G on January 07, 2021, 12:24:53 PM ---I used the silicone tubing as well as it needs to be the .5mm wall thickness.
Cant remember where it was from but Ash gave me the link. :)
--- End quote ---
Same as I gave to Trigger see above post
--- End quote ---
I thought the link you sent me Ash was, Hill Top >>> https://www.hilltop-products.co.uk/silicone-rubber-tubing-black.html
But, i think you commented on that it was not Black, Black ;)
--- End quote ---
Yes ..sorry you are correct ...It's the black silicone stuff i linked you to (which should last forever) but not jet black. What's the semi-rigid stuff like ? How rigid is it compared with original rubber sleeving ?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version