SOHC.co.uk Forums > CB750

Crankcase disaster.

<< < (4/5) > >>

SumpMagnet:
looks better inside than I thought it would do.

philward:
Good job so far!

Seamus:
Good luck with the repair, At least you know its possible.
Had similar with a K1 750, working on the motor and found a load of epoxy resin around the front of the sprocket. Damage where the chain had popped in for a visit. I was very fortunate as a mate had a bit of Kawasaki case that could be made to fit and had it welded up by an FIA approved aircraft welded. Only cost me a case of beer too.

Johnny4428:
Yes very annoying to discover the damage. I need to speak to a “metal smith” now and arrange repair. If the worst comes to the worst I know where to source replacement cases but would like to have these repaired.

Trigger:
If you are going for a weld repair, make sure the gear box is in place as, some of the cogs are very close to the case  ;)

Navigation

[0] Message Index

[#] Next page

[*] Previous page