SOHC.co.uk Forums > CB500/550

Generator electrical cabling grommet

(1/1)

cantarauk:
Are there any workaround or suggestions to repairing/replacing the plastic/rubber grommet items as shown below. The one on the left is so damaged and old that pieces are just falling off each time a touch it.



My current thought is to get plastic pieces 3d printed and creating an new cabling run for stator, coil, oil, neutral, etc which would be routed through these printed pieces and then epoxy to seal.

All suggestions and comments welcomed here

Nurse Julie:
They really need to be made of rubber as they compress to seal.

mike the bike:
You can use a standard circular grommet,  you don't need a D shaped one.

cantarauk:
Cheers. Will give that a go. Mine is so old it solidified which made me think it was plastic

Navigation

[0] Message Index