Other Stuff > Tricks & Tips

changing bearings in aluminium housings

(1/3) > >>

MrBoo:
I own a 1964 CB72.  The Honda workshop manual shows a method for removing the camshaft from the cylinder head: take a plastic hammer and a drift and hit the outer race of the camshaft bearings.  I did this as a teenager and the method is likely to damage the bearings.  Much better to warm the cylinder head with a hair dryer for 10 to 15 minutes.  Differential thermal expansion allows the steel bearing races to slide easily in the aluminium housings.  That is, the aluminium housing expands more than the steel bearing when heated.  50 to 60 degrees centigrade is usually enough to allow the bearings to slide while not being too hot to hold.

AshimotoK0:
Please introduce yourself Mr. Boo .. as I have a UK '64 CB72 I am restoring and always good to compare notes.

Some literature here which I scanned and are also in  my Dropbox links on here (along with other bike literature)

CB77 Service Manual:
https://www.dropbox.com/s/vs8c1fke3tcohpv/honda-shop-manual-CB77-superhawk.pdf?dl=0

1962 CB72 MCM review
https://www.dropbox.com/sh/1ly92qmzivx1ina/AAD4TwKvGkiEs14baZ_2krIGa?dl=0

CB72/77 Green v 2 Parts Book
https://www.dropbox.com/s/92db91hr189sazi/CB72_77%20Parts%20Book_2.pdf?dl=0

CB77 Parts Manual

https://www.dropbox.com/s/bwa12mrrriberq6/partslist_cb77_170513_0708.pdf?dl=0

Laverda Dave:
I agree Mr Boo. I've just had to remove the countershaft bearing from the Z400J engine. I wasn't going to chance tapping it out especially as I need to reuse it. I used the electric paint gun around the area and it just fell out!

K2-K6:
For bearing removal

[ Guests cannot view attachments ]

Quite a neat concept and not too hard to make, possibly.

K2-K6:

--- Quote from: Oddjob on February 09, 2021, 07:42:58 AM ---Good idea that. Would be even better with a screw one slide hammer for blind bearings.

EBay? K2

--- End quote ---

Yes, they use a small slide hammer on them. This source is specifically from Commencal MTB company for pulling bearings on rear suspension links etc like this picture of a rising rate shock linkage.  Similar in restrictions to some of the SOHC situations, these are paired and so difficult to get to the back of them.

  [ Guests cannot view attachments ]

Neat bit of thinking though.

Navigation

[0] Message Index

[#] Next page