General > Out & About

OUT AND ABOUT 2021

<< < (21/45) > >>

mike the bike:
I'm using 5 ohm coils.  Some people use 3 ohm or less and the system has excessive current consumption and overheating.

K2-K6:
My understanding of it is that often a lower resistance coil has been advised to give a "high energy" output, with it as much of a bodge as it appears.

5 ohm is used with points on these bikes as the dwell, although at the same angle throughout rev range, alters in time with crank speed. And so and aggregated specification of 5 ohm allows them not to overheat at continuous low rpm through over saturation, but still making decent spark at high rpm.

Electronic doesn't ordinarily vary dwell, it just uses the crankshaft pulse as a starting trigger ( if designed properly) to then let the transistor circuit switch coil saturation at ideal and constant dwell, for any rpm. As such it shouldn't draw any more demand at low rpm as the logic internal to system cuts input without overrun, but still makes the same dwell time at full rpm.

The coils should match the advice given for the system in use. 5ohm coils on 3ohm designed dwell should give sub optimal performance at full rpm.

K2-K6:
Apologies for thread drift as it's a technical subject that's not part of the great travel stories on this one.  :)

Johnwebley:
At Lower lode,just south of Tewkesbury, on the Severn,



Sent from my SM-A750FN using Tapatalk

Nurse Julie:
Nice little pootle out today on the 550 Mongrels. When we were out on Sunday, we saw this lovely old Royal Mail delivery van. Never seen it around here before but it belongs to a chap in our village.

[ Guests cannot view attachments ]

[ Guests cannot view attachments ]

[ Guests cannot view attachments ]

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version