SOHC.co.uk Forums > CB750

Smaller disc alternative spoke wheels CB750 project ideas

<< < (2/5) > >>

Seamus:
No, I was thinking of going over for a look as they are not too far away. I actually found the first link on the US site.

Some very interesting stuff and very good quality. I may need to fit some new guides to mt K1, so could well ask them to do that bit.

I have not really decided if that is my problem, but will be have a better idea when I remove the exhausts and see if there is oil in the exhaust ports.

Yoshi823:
I agree about the 750F1/F2 rear disc...

750F1

750SS

The disc that was on the rear of my F2 was a standard one but machined down to a minimum that would take a much smaller caliper.I had bought and sized up the MB50 disc to go with the caliper but it would have meant a major remachine of the wheel hub so I didn't go that route after all.

Rozabikes Tim:
Now we are talking!

No reason why this idea would not work with F1 wire wheel then?

Yoshi823:
No reason why not at all...so long as you can source a small caliper and make up a mounting for it.I had the material to hand at work so it was just a case of a bit of measuring and machining...and it worked.It wasn't as ferocious as the massively oversized rear,but with a set of Ferodo pads in the MB50 caliper it was sufficient.

Rozabikes Tim:
What pipe were you running on your bike in the piccy with the small rear disc?

Navigation

[0] Message Index

[#] Next page

[*] Previous page