SOHC.co.uk Forums > CB500/550
Cb 550 ss spain
murdock:
I'm sorry, I have not understood, is this?
murdock:
lo que si he visto es que en todos los cilindros y en todas las alturas o posiciones ,siempre con la falda del piston
numero 1 tengo el mismo gap que en la foto , varia muy , muy poco
what I have seen is that in all cylinders and in all heights or positions, always with the piston skirt
number 1 I have the same gap as in the photo, it varies very, very little
murdock:
sorry, I have modified the above message that came out in Spanish
Bryanj:
How big a feeler gauge can you get into the gap between bottom of piston and cast liner at one of points of yellow arrow? If over .002 inch (.08mm) piston or bore or both is worn
murdock:
thus 0.010, mm but in the other direction does not enter 0.04 mm
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version