SOHC.co.uk Forums > CB350/400

How do I hold this shaft to undo the end nut?

(1/4) > >>

McCabe-Thiele (Ted):
I probably should have done it before I removed the clutch etc what's the best way to hold the shaft to loosen this nut?  Is it by popping in a pair of gudgeon pins and putting a shaft through to hold the con rods fast?

I need to remove the circlip to the bearing then somehow presumably tap out the bearing any tips?

..


this nut by Macabe Thiele, on Flickr

Bryanj:
Put the clutch basket back on an jam a copper waser between the teeth(a penny will do)

McCabe-Thiele (Ted):

--- Quote from: Bryanj on March 15, 2021, 04:30:22 PM ---Put the clutch basket back on an jam a copper waser between the teeth(a penny will do)

--- End quote ---

Is there not a risk of chipping the teeth doing this?

Johnwebley:
The copper washer should be soft enough,

The RD Yamaha forum recommends a wedge of cloth to jam the gears

Sent from my SM-A750FN using Tapatalk

Bryanj:
Not chipped one in 50 yrs but if the quenn knew how many pennies and old halfpennies i had mangled oooer

Navigation

[0] Message Index

[#] Next page