SOHC.co.uk Forums > CB350/400
How do I hold this shaft to undo the end nut?
McCabe-Thiele (Ted):
--- Quote from: Skoti on March 15, 2021, 08:46:53 PM ---Would an impact wrench not loosen it?
--- End quote ---
This is my plan.
Johnwebley:
Back in the day,
An impact wrench was a chisel and lump hammer.
Oh
And the blue boxed Wessel with Phillips bits that chewed the heads
Sent from my SM-A750FN using Tapatalk
H2Eric:
--- Quote from: Johnwebley on March 16, 2021, 09:24:12 AM ---
And the blue boxed Wessel with Phillips bits that chewed the heads
Sent from my SM-A750FN using Tapatalk
--- End quote ---
That's because the screw heads were JIS (Japanese Industry Standard) and not Philips
McCabe-Thiele (Ted):
Okay nut now undone with cordless impact tool - prevented shaft rotation with long JIS shaft through gudgeon pin with plastic pipe sleeve to prevent marking the casing, cam chain was free from casing sides. Gear, spacer Circlip, bearing and shaft etc removed as per the video link below courtesy of "smoothoperator".
.https://www.youtube.com/watch?v=P1pTk2951lU
philward:
--- Quote from: H2Eric on March 16, 2021, 03:15:46 PM ---
--- Quote from: Johnwebley on March 16, 2021, 09:24:12 AM ---
And the blue boxed Wessel with Phillips bits that chewed the heads
Sent from my SM-A750FN using Tapatalk
--- End quote ---
That's because the screw heads were JIS (Japanese Industry Standard) and not Philips
--- End quote ---
Which back when I was starting biking, I (and many others) didn't know! The brit boys said Jap crap screws was made of 'monkey metal' not knowing about JIS
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version