SOHC.co.uk Forums > CB750

Taper roller bearings

(1/3) > >>

UK Pete:
I was looking at my new taper roller bearings for my F2 which came from dave silvers, they come without instructions ,not much of a problem but there is a big thick washer that has the same internal diameter as the lower bearing, would any one know if i have to use this, the thin original one and the rubber seal, or just the new thick one and rubber seal. or do i have to use the thick new one atall
Pete

Spitfire:
I got my taper roller kit from DSS for the F1 and used the new thick washer only, my rubber seal vanished years ago, but I think it is supposed to be used looking at mine.





Cheers

Den

Spitfire:
Just found this.

Cheers

Den

UK Pete:
I just put all mine together and i think it would of worked better with the old thin washer and rubber, it seems like the top bearing is too thick and does not sit far enough down in the head, so when assembled there is only four or five threads of the top stem poking through. if i had used the old thin washer i would have had 3 of more threads , i dont think this head bearing kit is worked out very  well for the F2
Pete

Spitfire:
That will go in the memory bank for when I get that far with my F2, you wouldn't think there would be that much difference.

Cheers

Den

Navigation

[0] Message Index

[#] Next page