SOHC.co.uk Forums > CB500/550

Rear hub

<< < (2/2)

K2-K6:
See what you mean with the two drawings.

That item 21 is effectively spacing the centre of the bearing to the swingarm to enable it to clamp the bearings when you tighten the spindle. All the other components are rotating with the wheel. 

Think it's quite difficult to describe but fairly easy to assemble. 

Sesman:
Yes, fully agree. Iv’e just built up the hub based on the second drawing and it seems to be correct. All a bit confusing for someone of my limited knowledge, but I only want to do it once safely.

Thanks for your reply.

Bryanj:
Those are both parts drawings NOT assembly drawings, the LH threaded retainer holds bothe the bearing against the internal shoulder and the sprocket carrier onto the hub

Sesman:
Thanks to all. Finished now.

Navigation

[0] Message Index

[*] Previous page