Other Stuff > Misc / Open

Mr P****s strikes again.

<< < (3/3)

K2-K6:
I can't see why you'd "want" a gap there, and they don't appear to be forthcoming with a convincing reason, so either can't be arsed to understand or the person that decides it should be that way doesn't elaborate  :) always seems suspicious if it can't be explained  ::)

But then I don't see that their heavy duty head studs can do what they claim either. ;D but that's another complete subject.

I doubt if it will make much difference,  but if Suzuki designed, cast and specified it in original form, then I'd favour their expertise over ape, unless ape can forward a clear advantage and reasoning to contradict manufacturer.

royhall:
I'm convinced these guides go with gas flowing. They would remove an amount of material around that guide exposing the guide taper otherwise they are simply too short. It wasn't a very good answer this is it "They are correct. In high performance application's we do not run the long exhaust. WE install many of these in GS1000's. Regards Jay. Tech"

Navigation

[0] Message Index

[*] Previous page