SOHC.co.uk Forums > CB500/550
Boot plug for intake manifold
thomaspigeon:
Haha No problem Bryan, I found it. It’ll take a month to arrive though. Do you know the bandwidth of yours?
I found some 9mm (which is 3mm less than mine), is it narrow enough?
Also I found some cb550 inlet manifold in Germany for £40, worse the shot? I guess I’ll have to change the O-ring straight away. Find the links below. Cheers
https://www.ebay.co.uk/itm/253627467056
https://www.ebay.co.uk/itm/373513175775
Bryanj:
O rings are same as tappet caps so readily available, if the rubbers are soft enough to use those are wrth a shot i will measure the clips i got seem to remember 8 or 9mm, you will need to cut off lots of extra when you put them on
mickwinf:
if you have not ordered the maniolds i have a pair of the correct ones, £25 pair plus post
thomaspigeon:
@oddjob, jubilee clips ordered. A bit expensive but if that does the job I’ll be happy. Thanks for the tip.
thomaspigeon:
--- Quote from: mickwinf on May 07, 2021, 07:01:23 PM ---if you have not ordered the maniolds i have a pair of the correct ones, £25 pair plus post
--- End quote ---
I have PM’d you about it. Thanks
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version