SOHC.co.uk Forums > CB500/550

fork seals

(1/3) > >>

mickwinf:
I have a leak from my fork seal on my 550. They were replaced when i rebuilt the forks and done about 60 miles since, the fork leg is not pitted. I also had a leak at the allen screw at the bottom that holds the stanchion in which i thought was the copper washer so replaced that and thought that was job done. now i am not sure if it was fluid leaking from the top seal and running down or was actually the washer? So any recommended suppliers of seals and any tips on fitting, although it seems easy enough and done it before but why is it leaking so bad?

Bryanj:
I have seen leaks round the outside of the seal where the casing was damaged when removing old seal. Could easily be just a bad seal i have not heard of any realy bad ones but they may be out there

Nurse Julie:
Are the ones you fitted the double spring type Mick, with the dust spring on top and the oil spring underneath?

mickwinf:
Hi Bryan, fork legs look undamaged but will check closely. Julie i can not remember what the seals looked like think i got them from ebay. Do you supply them? is it worth paying Honda price? the other side seems fine.

Nurse Julie:

--- Quote from: mickwinf on May 09, 2021, 04:49:25 PM ---Hi Bryan, fork legs look undamaged but will check closely. Julie i can not remember what the seals looked like think i got them from ebay. Do you supply them? is it worth paying Honda price? the other side seems fine.

--- End quote ---
No, I don't have stock of the Mick but I know we have fitted the Honda double sprung ones to most of our bikes.

Navigation

[0] Message Index

[#] Next page