SOHC.co.uk Forums > CB350/400

"O" Ring and Seals list for CB400F Eng/trans - Is there a full list please ?

<< < (3/3)

400 Cafe Racer:
Hey Deano, thanks - thats brill  :)

It makes the job so much easier to know these things in adavance.

Am I right in assuming  that the starter motor "O" ring is a seperate item, would you know if Nurse Julie can supply this as well. ?

Thanks for all your help.  :)

Dennis

Deano400:
Yes she does. Have a look at her Ebay items. If there's anything there that you need PM her and she will sort you out.

https://www.ebay.co.uk/sch/m.html?_ssn=julies9731&_osacat=0&ssPageName=STRK%3AMEFSXS%3AMESOI&_odkw=&_from=R40&_trksid=p2046732.m570.l1313&_nkw=CB400&_sacat=0

400 Cafe Racer:
Thanks again Deano,

I didn't know Nurse Julie had a site, so that will be very useful for the future.

This engine was fully stripped to rebuild by PO some 3,000 miles/4 years ago so not expecting too much hastle with bolts etc. I think at the time some seals and "O" ring changes were overlooked, hence my strip down now.

I'm part way into the strip down now, Seat and Tank off, Carbs and coils off, Breather cover and tappet covers off, tappets slackened to reduce cover stress when camshaft cover is removed. Side tracked to remove oil filter and drain sump, but found the Oil filter centre bolt will not shift. I've tried using a 6 sided socket and extension bar, plus tapping the wrench while under load without result.  Just ordered a 12mm SnapOn Flank Drive socket to use on my air driven impact wrench and considering whether to warm the area slightly before impacting.

Many thanks

Dennis  ;)

Navigation

[0] Message Index

[*] Previous page