SOHC.co.uk Forums > CB350/400

Carburettor throttle return spring

<< < (3/3)

Oddjob:
This was discussed at quite some length in one of my posts, it was the considered opinion that using a small split ring (like off a key ring) is a good solution, just slip it onto the end of the spring and the post it supposed to hang off. It has to be a small split ring though, any beach fisherman has a few in his tackle box as they come in handy for beach weights etc

allankelly1:

--- Quote from: Oddjob on June 01, 2022, 02:53:37 PM ---This was discussed at quite some length in one of my posts, it was the considered opinion that using a small split ring (like off a key ring) is a good solution, just slip it onto the end of the spring and the post it supposed to hang off. It has to be a small split ring though, any beach fisherman has a few in his tackle box as they come in handy for beach weights etc

--- End quote ---



Sent from my iPhone using Tapatalk

Oddjob:
I don't need to say this but just in case I think I should. The spring should still be under tension with the split ring fitted or everything just falls apart when the throttle is let go suddenly. A small 10mm ring should be good enough but test and see and if not go a little bigger until you get the spring tension you feel you can live at whilst still retaining positive throttle closure.

Navigation

[0] Message Index

[*] Previous page