SOHC.co.uk Forums > CB500/550

gap

<< < (3/8) > >>

murdock:
Obviously the author of the manual was not a sociable person or somebody disturbed, I don't know ..jua jua
but I still do not know what the gap would be that I should request from the machinist between cylinder and piston

murdock:
if someone fills this photo correctly it would do humanity good

Nurse Julie:

--- Quote from: murdock on May 26, 2021, 02:43:13 PM ---if someone fills this photo correctly it would do humanity good

--- End quote ---
Your picture is incorrect. The piston will be in the centre of the bore and as you are using Cruzinimage pistons you need a piston to bore clearance all round  at the piston skirt of 1 thou inch which equates to 0.0254mm

murdock:
Ok, perfect, thank you very much

fogrider:
So to fill the figure in on Murdocks' drawing would be two thou , one each side ?

Navigation

[0] Message Index

[#] Next page

[*] Previous page