SOHC.co.uk Forums > CB500/550

Keihin Carburetor parts

<< < (3/3)

Sesman:
 :o :o :o

deltarider:

--- Quote from: Nurse Julie on June 02, 2021, 07:55:07 PM ---
--- Quote from: Sesman on June 02, 2021, 07:10:27 PM ---On the topic of Classic Octane, I notice he bench syncs his carbs with an 1/8th” drill bit from the choke side (eg slide cut out side) rather than engine side. Is that correct?

--- End quote ---
Either side is fine but it's a lot easier going in from the non choke flap side. I've never understood why anyone would even consider going in from the choke side 🤔🤔🤔🤔

--- End quote ---
+1 I always did it from the engine side and used a small allen key. If you are concentrated and take your time, it's possible get a sync thus close, you won't need a further dynamic vacuum adjust.

Bryanj:
1/8 is bigger than i like to use, i have some 1mm about, unused so no marks from burs on the shank. I also did a right up on bench sync, should be in tips and tricks

Navigation

[0] Message Index

[*] Previous page