SOHC.co.uk Forums > CB500/550

CB550 1977 F2 twin disc conversion

<< < (4/5) > >>

Bryanj:
M10x1.5 i think but not a lot of thread for a banjo bolt, i use an adaptor to a swivel fitting

murdock:
tank you , I will look for something to adapt

murdock:

--- Quote from: murdock on June 15, 2021, 07:41:13 PM ---tank you , I will look for something to adapt

--- End quote ---

I have to ask again, I have looked below on the caliper without disassembling it and yes, it looks like 10 x 1.5
The one above, the one with the master cylinder is also like this?

Bryanj:
I think they are all the same thread

Sesman:
On this topic, does any forum member have a quick fix to duplicate the brake hose retainer on the mudguard. This is for the double disc conversion. I’m stuck between a wire bending and welding exercise followed by a mudguard rechrome or a new replacement guard with a ready made solution, if it exists.

Navigation

[0] Message Index

[#] Next page

[*] Previous page