SOHC.co.uk Forums > CB500/550

Carburetor rebuild

<< < (2/2)

fogrider:
Magnus, there must be a bit showing  through in the  choke area, like the photo,  as it is the air/fuel mixing chamber. To tell which way up, most of the emulsion tube holes should be towards  the lower end and the thick end of the needle should just fit in the jet at the top of the emulsion tube.
Hope that helps .
Regards from East Yorks.

Sesman:
Second that advice. My carbs where a virgin rebuild and the emulation tubes have orientation as described in the previous post.

Navigation

[0] Message Index

[*] Previous page