SOHC.co.uk Forums > CB500/550

Separating top end from bottom end in one piece?

<< < (7/9) > >>

Sesman:
In respect to the Vesrah kit, did you use the o rings that came with the kit? I’m advised to use a 3mm thick o ring for the cylinder head oil valves rather than the standard 2.5mm item?

Bryanj:
Pm sent Ken

alexdecker:

--- Quote from: Sesman on July 29, 2021, 03:58:13 PM ---In respect to the Vesrah kit, did you use the o rings that came with the kit? I’m advised to use a 3mm thick o ring for the cylinder head oil valves rather than the standard 2.5mm item?

--- End quote ---

Yes, I only used sealers and O-rings from the Vesrah kit…

- Alex

Sesman:
Cheers Alex.

Johnny4428:
Hi guys, further to this topic on  o ring sizes for cylinder head oil way seals I’ve measured this morning as I was going to fit cylinder head. The machined recess in the surface of barrels is 1mm and my vesrah gasket is 1.65mm I dont see a 2.5mm o ring being a lot of benefit here. I actualy found a 2.65mm o ring in a set I had but even this is not going to cut it. Am I right in thinking this has going to have to be 3mm thick rings?

Navigation

[0] Message Index

[#] Next page

[*] Previous page