SOHC.co.uk Forums > CB350/400
DYNATEC HT Coils - Plug Leads - Plug Caps, opinions on compatible set ?
McCabe-Thiele (Ted):
Hi Dennis,
My leads are marked as follows - "8mm High Tension Silicone Jacket 18 Conductive Silicone "
the leads came with the kit.
Cheers Ted
400 Cafe Racer:
Thanks Ted,
It looks as though the HT leads I have fitted are not the originals with the kit then.
I will do some more research before deciding which way to go with replacements.
Cheers
Dennis
McCabe-Thiele (Ted):
--- Quote from: 400 Cafe Racer on August 06, 2021, 09:10:29 AM ---Thanks Ted,
It looks as though the HT leads I have fitted are not the originals with the kit then.
I will do some more research before deciding which way to go with replacements.
Cheers
Dennis
--- End quote ---
Could be they have upgraded over time out of interest what colour are your coils? Mine have a push on rubber connector at the plug ends - no resistor cap.
400 Cafe Racer:
H Ted,
Pictures attached below. Looked through the invoices from PO and they were purchased in 2016 from 4into1 San Francisco and appear to have done about 5k miles since, with Electronic Ign being added in 2020.
McCabe-Thiele (Ted):
--- Quote from: 400 Cafe Racer on August 06, 2021, 09:12:01 PM ---H Ted,
Pictures attached below. Looked through the invoices from PO and they were purchased in 2016 from 4into1 San Francisco and appear to have done about 5k miles since, with Electronic Ign being added in 2020.
--- End quote ---
Mine have Green Bodies purchased in July 2020 as a complete system from I think it was a Yamaha Dealer in the UK.
.Dyna Coil by Macabe Thiele, on Flickr
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version