SOHC.co.uk Forums > CB350/400

Generator bolt

<< < (2/2)

allankelly1:
Ok

Just checked my rear spindle and it’s M16


Sent from my iPhone using Tapatalk

Bryanj:
Dont think the rear wheel is same and you need someting you can beat hard as the rotor is, or should be, on tight

allankelly1:

--- Quote from: Bryanj on August 12, 2021, 07:50:25 PM ---Dont think the rear wheel is same and you need someting you can beat hard as the rotor is, or should be, on tight

--- End quote ---
Yes they are usually quite tight but tonight found out bolt was just past finger tight and so was the counter shaft pinion retaining bolt too

Not moaning as its a strip down but hopefully the rotor is just snuggly on its taper

Best wishes Al


Sent from my iPhone using Tapatalk

allankelly1:
That worked a treat and a nice fit considering I did a guess on the thread depth when thread cutting on the lathe at work



Also made one of these too for the clutch nut




Sent from my iPhone using Tapatalk

Navigation

[0] Message Index

[*] Previous page