SOHC.co.uk Forums > CB350/400

Routing the four float bowl drain pipes...

(1/2) > >>

Athame57:
I just got a set of four float bowl drain pipes at the same time as I found myself a seemingly extinct genuine Honda air box element, bye bye scotch brite a while. ;D
They came with clips and two rings... it takes all four pipes to make them fit and I now see that Honda intends we secure all four together, but I've never seen the proper way they are meant to terminate. What is the official or best way to route these?  :-\   

McCabe-Thiele (Ted):
I'm not 100% certain but thought they terminate via the two clips on either side of the centre stand.

pipe clips by Macabe Thiele, on Flickr

Athame57:
I'll check they exist on my bike!  ;)

Laverda Dave:
That's where they exit on mine Ted although.....you also have the two overflow hoses from the top of the carbs to consider. Feeding three overflow pipes through each of those clips is very tight. I have fed the top overflow pipes outside of the clips without any problems.

Deano400:
The two clips in the picture are for the battery breather tube (right) and the air filter drain pipe (left). The carb overflow and vent pipes thread between the crank cases and swing arm. The air manifold breather threads through the hole at the rear of the crank cases.
See attachment.
[ Guests cannot view attachments ]

Navigation

[0] Message Index

[#] Next page