SOHC.co.uk Forums > CB350/400

Tail light mount.....

<< < (2/4) > >>

philward:
If you want a chrome lamp bracket - Alan found this source -

http://www.sohc.co.uk/index.php/topic,25399.15.html

I bought one for my US 500k2 and its good quality and cheaper than rechrome

Sesman:
I’ve got a job lot in at Prestige, so may ask for this to be added to the items they currently have. They were very reasonable on cost and judging by the cost of headlamp ears rear mudguard and chain guard I’d be surprised if the rear lamp mounting will cost more than a replacement. I’ll report here soon.

I’m back home next week so will measure that brake spring.

philward:

--- Quote from: Oddjob on September 08, 2021, 04:06:41 PM ---Did you end up trimming the top brackets down Phil? I bought a new number plate and it's still not wide enough, if I trim the ends down to just about where the bolt hole slots are I'll get away with it.

On mine it went straight on Ken - plate is 9 inch wide by 7 inch high

Be ok if you have a 3 figure number plate though as they are wider.

--- End quote ---

Sesman:
Early August. They have had two weeks holiday, but are back now I believe.

Sesman:
Philip, or Phil. Though I often get called worse by family and friends.

Incidentally, just checked my diary, my visit to Prestige was 15th July, but I do know they were on annual holiday for two weeks in August. I think they returned on the 16th, so your mate was a little unlucky. BTW it’s 6 months turnaround at Prestige at the moment. Agbrigg did some zinc plate for me in 2 days. Not sure on chrome, but I’m going to give them a try too.

Yes, still need that drive plate if you have it. I used countersunk screws in the end and reduced their depth slightly using a grinder. I’ve made a right mess of the original plate though getting the thing centralised.

Navigation

[0] Message Index

[#] Next page

[*] Previous page