SOHC.co.uk Forums > CB350/400

Aquablasting, polishing etc

<< < (2/2)

allankelly1:
This is my cases after aqua blasting




Been discussing on the RD forum how to finish and one suggestion is silver Ceracote as its thinner than paint and and very petrol and solvent resistant


Sent from my iPhone using Tapatalk

Ceeby-jeebies:
Thanks to everyone for their comments. Overall it looks as if polishing gives the best results, even if it’s not the way it looked when the bikes left the factory - while aquablasting also produces good results but seems then to need some other from of finishing.

Athame57:

--- Quote from: Nurse Julie on September 20, 2021, 08:17:05 PM ---...Graham polished the cases for me 4 years ago and I never had to take the tube of Solvol to them.

--- End quote ---
Men have go their uses,  ;D  but why didn't you make him clean up the underside of the rear mudguard.... it shows!  :o

McCabe-Thiele (Ted):

--- Quote from: Athame57 on September 20, 2021, 10:51:39 PM ---
--- Quote from: Nurse Julie on September 20, 2021, 08:17:05 PM ---...Graham polished the cases for me 4 years ago and I never had to take the tube of Solvol to them.

--- End quote ---
Men have go their uses,  ;D  but why didn't you make him clean up the underside of the rear mudguard.... it shows!  :o

--- End quote ---

Not original but I'd polish up to remove the visible rusting then a coat of some sort of underseal / Waxoyl to keep the noise down on gravel strikes!
I suspect the reality is a used bike will show use.

Navigation

[0] Message Index

[*] Previous page