SOHC.co.uk Forums > CB350/400

Do folk here Anneal Copper head washers?

<< < (2/3) > >>

McCabe-Thiele (Ted):

--- Quote from: amx1992 on September 22, 2021, 11:21:42 PM ---My original 400 ones were definitely copper plated steel, but I've replace them with solid copper ones so maybe someone has done the same in the past with yours Ted

--- End quote ---

Did you check if they were magnetic?

taysidedragon:
Mine were copper plated steel as well.

McCabe-Thiele (Ted):

--- Quote from: taysidedragon on September 23, 2021, 12:02:42 AM ---Mine were copper plated steel as well.

--- End quote ---

Cleary some are made from Copper plated steel then - would that be original fitting or an aftermarket fake item fited by PO's.

I have ordered 2 from DS as my two nuts down the plug holes had thin steel washers fitted - I hope the DS ones are Copper!

Nurse Julie:

--- Quote from: Macabethiele (Ted) on September 23, 2021, 11:25:00 AM ---
--- Quote from: taysidedragon on September 23, 2021, 12:02:42 AM ---Mine were copper plated steel as well.

--- End quote ---

Cleary some are made from Copper plated steel then - would that be original fitting or an aftermarket fake item fited by PO's.

--- End quote ---
Original fitting Ted. We have had engines in for work that have never been apart before where some have just the copper ones fitted and others have the copper/ steel type fitted.

Laverda Dave:
Ted, don't forget the two washers under the pillar nuts are dowty type.

Navigation

[0] Message Index

[#] Next page

[*] Previous page