SOHC.co.uk Forums > CB350/400

Rear disc conversion

<< < (4/29) > >>

allankelly1:
Hi

Yes it was my intention to hang the caliper below the swing arm and use the original torque arm fixed point on the swing arm to add the torque arm

Also had a dig about in the garage and have found the original hanger that came with the caliper

(Just will need a torque arm mounting point adding if I decide to use this)

 


And also have a possibly a remote brake master cylinder



So now that I have a disc on the way I have possibly all the main “bought in”components for this conversion

Once disc is here I will do the final disc carrier design that I will share here for critic and then crack on with its manufacture

Best wishes Al


Sent from my iPhone using Tapatalk

Laverdaroo:
Both of those will lick up a treat, that hanger needs minimal 'nannying' and come up a treat. Are you going to keep the reservoir or go for the HRC 'green tube' m/c 'get out of jail free card' option?
Think theyre about £9 or similar with the kit included on some sites. Might give you a number of different options for mounting, just depends how much modification you need to do to get the desired effect I guess. yo ucan hide it behind the frame rail though if it needs hiding???

allankelly1:

--- Quote from: Laverdaroo on October 12, 2021, 10:06:53 PM ---Both of those will lick up a treat, that hanger needs minimal 'nannying' and come up a treat. Are you going to keep the reservoir or go for the HRC 'green tube' m/c 'get out of jail free card' option?
Think theyre about £9 or similar with the kit included on some sites. Might give you a number of different options for mounting, just depends how much modification you need to do to get the desired effect I guess. yo ucan hide it behind the frame rail though if it needs hiding???

--- End quote ---
Thats a good option if needed

Thanks for the info

Best wishes Al


Sent from my iPhone using Tapatalk

Laverdaroo:
https://www.ebay.co.uk/itm/Genuine-HRC-Honda-Racing-Corporation-Complete-Rear-Brake-Reservoir-4-Parts-Kit-/114336241932?var=0&mkevt=1&mkcid=1&mkrid=710-53481-19255-0&campid=5338268676&toolid=10044&customid=CjwKCAjwh5qLBhALEiwAioodsz5QQqvqf2gv2nbJ4PAEZ3A0CAFWCPgktpJ5elL3NHQqwP2WOi2uyhoCnqcQAvD_BwE

Arfa:
Wow Alan, that's quite something for a spot of tinkering, well done.

Navigation

[0] Message Index

[#] Next page

[*] Previous page