SOHC.co.uk Forums > CB350/400

On a genuine CB400/4 rear mudguard how many number plate mounting holes?

(1/5) > >>

McCabe-Thiele (Ted):
My rear mudguard only has three holes for the rear number plate bracket I assume this isn't original as the grommets on the plate holder indicate four mounting points?

I can fit the unit by using the two upper rubber cushion mounts and the centre bolt hole on the bottom bracket as it was when I took it off.
Parts manual not much help as it appears to just show the upper mounts.

Is it for the USA model ?

Bryanj:
If the parts book shows 2 different guards then probably

allankelly1:
Hi Ted

My original Uk plater holder had four bolt holes and so did the rear mudguard as you can see in the below picture

Hope this helps

Best wishes Al




Sent from my iPhone using Tapatalk

mike the bike:
The US ones were chromed whereas the GB ones were painted black

allankelly1:

--- Quote from: mike the bike on October 23, 2021, 09:03:09 PM ---The US ones were chromed whereas the GB ones were painted black

--- End quote ---
Yes but both had four holes as I did a swap the one in the picture the other month to a chrome USA one


Sent from my iPhone using Tapatalk

Navigation

[0] Message Index

[#] Next page