SOHC.co.uk Forums > CB750

Front Brake Shaft

(1/2) > >>

Saesneg Shaun:
Hi,
I'm trying to rectify a squeaky front brake on my K6.
Probably a stupid question but should the piviot shaft be able to move both ends?
The top bit with 2 holes moves fine but the bottom is locked solid?

Nurse Julie:
Take top and bottom part out and clean up and grease it well. It should swivel top and bottom.

Saesneg Shaun:

--- Quote from: Nurse Julie on October 28, 2021, 02:39:12 PM ---Take top and bottom part and clean up and grease it well. It should swivel top and bottom.

--- End quote ---

Thanks NJ. I'll see if I can get it apart

K2-K6:
Put the bottom into a vice to hold, remove top (two hole part) see if you can get the seal out that's underneath that after removing, then spray penetrating oil into the seal gap. Keep doing that for a while then you should be able to rotate the arm on the spindle to free it and get the two apart for cleaning.

K2-K6:
By "bottom" I mean the opposite end of the pivot shaft to the two hole end.

Navigation

[0] Message Index

[#] Next page