SOHC.co.uk Forums > CB750

Trouble with fuel tank paint around filler

(1/2) > >>

the-chauffeur:

Guys

OK - my tank and side panels have come back from the sprayers, but having put fuel into the tank to start the bike up, the paint around the neck opening has started to soften and crinkle (I've had this happen before on another bike). 

How do you folks who've painted things prevent this from happening - and is there anything I can do about it now?  Alternatively, is there something I can put round the neck (like a large black rubber band or piece of bicycle inner tube) to disguise the effects of the fuel on the paint/lacquer?

Thanks

Neil

UK Pete:
Neil what i did on my gpz 550 tank i sprayed was to sand back the paint to bear metal around the sealing part of filler neck or trim it back with sharp knife if all soft , then spray a load of petrol resistant laquer in the lid of the paint can, and with a modelers brush paint the bare metal and the surrounding tank paint that was not seen under filler cap, or you could mask the area off and just do the prep and spray the area, Btw Halfords sell the petrol resistant laquer.
Pete

PMK:
Sounds like non petrol proof laquer was used.

Did you pay someone to do it? if so I'd give it back and say sort it!!

If was a mate then I'd do what UK Pete suggested.

Make sure that you mask the good paint properly as some laquers don't mix and cause real problems finish wise.

Hope that helps

honda-san:

I have found that two things are important here-

The paint should be trimmed back at the filler neck so that the seal is against bare metal rather than on top of the paint. Otherwise the petrol over time seems to work its way under the paint and down the outside, softening the paint as has happened (and Honda did not paint onto the sealing surface either)

And of course petrol proof laquer must be used - Surely ANY painter worth a damn knows that!!!

Cheers - Chris R.

the-chauffeur:

Folks, sounds like you were pretty much right all round.

Both of the painters I've used in the past a) painted far too high up the neck and b) didn't use petrol resistant lacquer.  No, don't tell me - I know, I know.  Never again.

Fortunately, I've saved the paint on the neck of the 750 by following your advice.  Cut it down, masked up and oversprayed with petrol reisistant - and it's now fine.  The neck of the CB450 is a different matter; it was too far gone to save.  So I stripped it back to where it meets with the tank, masked up and etch primed, flatted and oversprayed with a very close match mix (the original was a candy, but as well as cocking up the neck, the sprayer put too many coats on and the colour is nowhere near what it should be - again, please don't go there).  Finished with petrol resistant, and whilst not perfect, you'll only notice the colour difference if you really know what you're looking for.

I gotta find me a good sprayer.  Or maybe do it myself next time.

Thanks again.
 

Navigation

[0] Message Index

[#] Next page