SOHC.co.uk Forums > CB500/550

Carb actuating spindle removal

(1/2) > >>

Mariner Wayne:
Can anyone advise on how to remove the actuating spindle (pivot bar?) on a set of F2 carbs for cleaning and refurb?
Mine will move sideways in both directions for approx. 2-3 mm before stopping hard against something.
It's not obvious to me what is retaining it and hence how to remove it.
All advice gratefully received.
Thank you

Sesman:
Drill out the pin….posted very recently I believe.

deltarider:
What is there to refurb?

Mariner Wayne:
Thanks for this.
I can see the pin in question (I think).
I have looked and can't see a previous post about this.
I need to clean up the throttle cable pulley assembly and other items that are on the spindle as they are seriously rusty and stained and I can't do this without removing them off the spindle. Hence the question.
Appreciate the help

Nurse Julie:

--- Quote from: Mariner Wayne on October 31, 2021, 03:38:34 PM ---Thanks for this.
I can see the pin in question (I think).
I have looked and can't see a previous post about this.
I need to clean up the throttle cable pulley assembly and other items that are on the spindle as they are seriously rusty and stained and I can't do this without removing them off the spindle. Hence the question.
Appreciate the help

--- End quote ---

http://www.sohc.co.uk/index.php/topic,24343.msg220783.html#msg220783

Navigation

[0] Message Index

[#] Next page