SOHC.co.uk Forums > CB350/400

Comstar rear brake CB400/4

<< < (2/2)

PaulC:
Hi,

Looking at the photo you posted is why I believe the forks and comstar wheels are from a 250N mated to 400/4 stem. I was hoping the rear brake drum would be stamped with a part number.

Cheers

allankelly1:
Hi PX207

Just a a note I have been told that cx500 lower sliders are a straight swap on the CB400F stanchions if you were looking for a possible donor swap to a twin disc

Maybe a complete cx front end  may suit as I know from experience the cb400n sliders are not compatible with original CB400F stanchions without modifications for the internal bushes

Best wishes Al


Sent from my iPhone using Tapatalk

ka-ja:
The 400N front end with twin disks fit straight into the 400/4 yokes with no mods apart from a better master cylinder, but it gives you a 19in front wheel. I don't think the 400/4 rear brake plate is interchangeable with the 250N rear brake, I have had a similar setup since 1985, recently overhauled, but now on 18in front wheel

PaulC:
Just like to thank the forum members for their prompt and suggestive responses, I'm sure it won't be the last time for this mechanical newbie. Al your a life saver, given what ka-ja has just stated 😀  8)

Navigation

[0] Message Index

[*] Previous page