SOHC.co.uk Forums > CB500/550
Genuine or fake? Your thoughts?
Charliecharlcomb:
--- Quote from: philward on November 07, 2021, 11:07:39 PM ---Just re-assembled the carbs with all new Keyster parts - starts and ticks over fine but havn't had time to road test yet to see if hesitency cured (although starts much better).
But! I seem to have misplaced one of the zinc plated circular blank off the carb body (at top of carb). Probably find it in corner of garage in a few years!
Has anybody got a scrap carb that they could take one off and sell me? Carb is 627B Type
--- End quote ---
Just seen this thread. Interested to know if you have had a proper test ride and whether it has solved the problem. I have been through the same journey myself and only fixed everything when I realised the needles and emulsion tubes have to be matched, i.e. come from the same source as the pattern ones will be subtly different to the originals. Good luck!
philward:
Can't give a definative answer yet Charlie - since fitting the Keyster parts, it starts better but have only done about 20 miles and although all seems fine' didn't have many opportunities to roll it on in the mid range under load (where the problem was) due to traffic.
Will update when I've more info
Navigation
[0] Message Index
[*] Previous page
Go to full version